If you are setting up a studio or gym with multiple bikes which will all use the same console settings, you may export the console configuration settings in order to upload them to all bikes in order to save time. 


The following custom console settings can be saved to a USB drive:


  • Unit of measurement
  • KCAL Toggle
  • Backlight duration
  • Contrast level
  • Auto pause setting
  • USB port setting


The full instructions can be found on page 29 of the Stages Indoor Cycling SIC1 Console User Guide.


Console Button Guide




Steps to save your console settings:


The custom console settings will be saved in an import.cfg file format.


1. Activate the console by pressing any button.


2. Insert your USB drive into the USB port on the console.

Make sure that the USB port on the console is enabled (see Stages Indoor Cycling SIC1 Console User Guide, step 3 on page 27).


3. Press and hold the Backlight and AVG/END buttons for 5 seconds to enter SETTINGS menu


4. Select SYSTEM from the menu


5. Select FIRMWARE from the menu


6. Select SAVE CFG from the menu. The console will begin saving the custom console settings to the USB drive and the word SAVE--- will appear in the message banner.


7. If the custom console settings are saved successfully to the USB drive, the word DONE will appear in the message banner.



Steps to import your console settings:


1. Activate the console by pressing any button.


2. Insert the USB drive that contains the import.cfg file you intend to use

Make sure that the USB port on the console is enabled (see user guide, step 3 on page 27).


3. Press and hold the Backlight and AVG/END buttons for 5 seconds to enter SETTINGS


4. Select SYSTEM from the menu


5. Select FIRMWARE from the menu


6. Select the IMPRT CFG menu option on the firmware menu. The console will begin importing the custom console settings to the console and the word IMPRT--- will appear in the message banner.

Tip: You can also use this shortcut to select the IMPORT CFG menu option: Press and hold the BACKLIGHT and STAGE buttons for 3 seconds.


7. If the custom console settings are imported successfully to the console, the word DONE will appear in the message banner.